Gantry profile luminaries Column lighting bar Installation

Gantry profile luminaries Column lighting bar is very popular in jewelry stores, watch stores, and museum etc. It's also very easy to install, so let's see if it's installed.

1. LED light bar connect to the wire (terminal connection is very convenient).   

2. Insert the LED light bar into the aluminum groove.

3. At the end of the wire, line the fittings through the fittings 1 2 3 4, then screw them all (the other side is the same).

4. Pull the line down a bit, then insert the aluminum groove into the fitting 1 and pull the line through ( Both side).

5. After assembling, measure the distance supported by both ends, then place the hole in the place to be installed. The hole can not be opened too big, smaller than the diameter of the fitting 3, and larger than the diameter of the fitting 4.

6. Hole opening after the lights on both sides of the support in the hole (4 parts), and then use the nut from the bottom (5 parts) and tighten.

7. Connect the power, loosen the two screws of the fitting 6, then insert the line of the connecting light bar and fix it. Then connect the power plug and the light is on.

8. You can also connect the transformer directly with the wire that connects the light bar, and then connect the 110-240V power.